1203

This site is protected by Trustwave's Trusted Commerce program"
Free return shipping
for continental US and Canada
screen repair
1-855-630-1111
+1-206-299-0699 outside of continental US and Canada
LIVE CHAT Offline
M-F 3am - 9pm.
S-S 11am - 7pm Eastern Time
SUPPORT Contact
24/7
We ship from: FREE US and Canada shipping for 10+ screens orders
Our inventory is live, over 131000 screens in stock!

LAPTOP SCREENS MADE BY LG, PHILLIPS, AUO,
SAMSUNG, HANNSTAR, CHI-MEI Details

Brand new screens
Every order ships same day

iPhone 5 LCD SCREEN AND GLASS DIGITIZER INSTALLATION AND REPLACEMENT GUIDE

This is a guide on replacing a screen on the Apple iPhone 5. For more details please watch the video below:

The screen is integrated with the digitizer, and is replaced with the entire front assembly.
1. Turn off the iPhone by holding the power button at the top and confirming the shut down on-screen.
2. Use a SIM card tray removal tool or a paperclip to take the SIM card tray out.
3. Next, remove 2 pentalobe screws on the bottom.
4. Place a suction cup close to the "Home" button so the button is not overlapped.
Place your left thumb firmly on the earpiece.
Pull on the suction cup to open the front assembly from the bottom side.
5. Carefully open up the front assembly, do not separate it from the main body completely.
Remove 3 small screws securing the EM shield to gain access to the connectors. Please note that the top right screw is larger than the rest.
Remove the EM shield by gently shifting it to the left and lifting it out.
6. Disconnect the 3 connectors with a pick or a flat screwdriver.
Please be extra careful since the connectors are very fragile.
Set the old screen aside.
7. Take out the new screen and gently connect the 3 connectors back to the logic board.
8. Replace the EM shield, and secure it with the 3 screws. Start with the top right one, which is the largest one.
9. Properly close the front assembly: insert the top edge into the groove first, make sure that is it properly aligned and gently snap the rest of the screen back in place.
10. Test your screen by turning on the phone. If the Apple logo appears the installation was done correctly. Turn off the phone again.
11. Remove the protective film from the LCD.
12. Replace the two pentalobe screws on the bottom.
13. Finally, replace the SIM card tray, and you are done!