Replacement of screen on Asus M509 screen replacement by laptopscreen.com

Shut down the laptop

To begin turn off the laptop and disconnect the power cord

Remove the bezel

The bezel is held in place with Phillips screws in the bottom corners. The screws are covered
with tiny pieces of plastic. Use an X-acto knife to remove plastic covers in the bottom corners.
Using Phillips screw driver remove two screws. Insert a plastic pick between the bezel and the
LCD. Move it along the perimeter. Separate the bezel. The bezel on this laptop was broken so
one of the hinge covers remained in its place. Put the bezel aside

Separate the screen from the rails

The screen is glued to two vertical rails. Remove two Phillips screws in the top corners two
loosen the rails. Use a plastic pick to separate screen from the rails. Place the screen on
the keyboard

Disconnect the old screen

Peel off the clear tape securing the video connector. Disconnect the video cable.
Discard the old screen

Connect the new screen

Place the new screen on the keyboard. Reconnect the video cable. Secure it with clear tape.
CAUTION! It is very important not to force any connectors. Also make sure not to twist or
slant the connector when plugging it in

Test the new screen

Lift the screen up and lean it against the back cover. Test the new screen. The screen is
working and we can finish the installation process

Install the new screen

The glue remaining on the rails is still sufficient to hold the screen. In case you need new
adhesive you can always buy adhesive strips on our site:
https://www.laptopscreen.com/English/section/tools/
Clean the sides of the screen with cloth and alcohol. Lift the screen up and glue it to the rails
applying some pressure. Fit the screen back into the back cover. Replace two Phillips screws
in the top corners. Remove the protective film

Replace the bezel

Replace the bezel. Start from the bottom then go around the perimeter snapping tabs back in
place. Turn the laptop sideways and make sure that the bezel is snapped in the bottom of the
screen. Replace two Phillips screws in the bottom corners. Replace two plastic covers.
Turn the laptop on and we are done!