Replacement of screen on Asus TUF FX506HCB screen by laptopscreen.com

Tools

For the replacement process we will need the following tools: Phillips screwdriver, Plastic pick

Shut down the laptop

To begin turn off the laptop

Remove the bezel

Remove two Phillips screws from bottom corners of the bezel. Normally the screws are covered
with a small round pieces of plastic but in our case they are missing. Using plastic pick pry off
the bezel on the inner edge. Go around the perimeter unsnapping the tabs underneath. Put the
bezel aside

Separate the screen

The screen on this model of the laptop supposed to be held in place with stripes of adhesive.
In our case the adhesive was already removed. So we just place the screen on the keyboard

Disconnect the video cable

Peel off the clear tape securing the video connector. Disconnect the video cable.
Discard the old screen

Connect the new screen

Place the new screen on the keyboard. Reconnect the video connector. Secure it with
clear tape. CAUTION! It is very important not to force any connectors. Also make sure not to
twist or slant the connector when plugging it in. Now we can test the new screen.
The screen is working and we can finish the installation process

Install the new screen using adhesive strips

In order to secure the screen in the back cover we are going to apply a set of adhesive strips
which you can buy on our site: https://www.laptopscreen.com/English/section/tools/
Using a micro fibor cloth and alcohol clean the sides of the screen and the bottom cover. Apply
the adhesive strips. Lift the screen up aligning it at the top edge. Make sure that the tabs stay
loose at the top of the screen. Apply some pressure to catch the adhesive. Remove the
protective film

Replace the bezel

Make sure that the video cable stays in place. Go around the perimeter snapping tabs back
in place. Replace two Phillips screws in the bottom corners. Replace two plastic covers if present.

Turn the laptop on and we are done!