Replacement of screen on Lenovo ThinkPad P52 screen made by LaptopScreen.com

Tools

For the replacement process we will need the following tools: plastic pick and a tweezers.

Shut down the laptop

To begin turn off the laptop and disconnect the power cord

Remove the bezel

Start removing the bezel. Use a plastic pick to pry off the inner edge from the screen.
Go around the perimeter unsnapping the tabs underneath. Put the bezel aside

Remove adhesive strips

The screen is held in place with adhesive strips with loose tabs above the top corners of the screen.
Using tweezers pick the tab on the right side and pull out adhesive strip. Pull out adhesive strip on
the left side. Place the screen on the keyboard

Disconnect the video cable

Peel off the clear tape securing the video connector. Using plastic pick open the connector’s bracket. Disconnect the video cable. Discard the old screen

Connect the new screen

Place the new screen onto the keyboard. Reconnect the video cable. Close the connector’s bracket,
secure it with clear tape

Test the new screen

Lift the screen up. Now we can test the new screen. Turn the laptop on. The screen is working
and we can continue the installation process

Install the new screen

Place the screen back onto the keyboard. As you can see the old adhesive strips were on the inner
surface of the laptop back cover. But in our case for convenience we are going to apply new
adhesive strips on the sides of the screen. By the way: We offer standard double-sided tape
for such repairs on our site: https://www.laptopscreen.com/English/section/tools/
Apply new adhesive strips making sure that their tabs will stay loose at the top of the screen.
Lift the screen up and apply some pressure on the sides .
Make sure that the video cable stays in proper position underneath the screen

Replace the bezel

Press firmly in the bottom corners and then go around the perimeter snapping tabs back in place.
Turn the laptop on, and we are done!