Netbook LCD de réparation, comment remplacer un écran LCD sur un Netbook [Dell Mini 10]

This is a step-by-step guide on how to replace an LCD screen on Netbook Dell Mini 10. Please watch the video or follow these steps below:

1 Please disconnect the power adapter from your laptop.

2 Flip the laptop over and remove the battery.

3 Start by removing 2 rubber screw covers at the bottom.

4 Proceed with removing 2 bezel screws located under the screw covers.

5 Now you can remove the bezel. Start on one side and move along the perimeter prying the plastic away from the screen. Set the bezel aside.

6 Now remove 4 screws holding the LCD panel.

7 Remove 2 frame screws on each side of the LCD.

8 There is a webcam cable that is attached to the LCD panel. Separate the cable and put the screen down on the keyboard.

9 Peel off the tape securing the video connector. Gently disconnect the video cable. Discard the old LCD.

10 Place a cloth or a paper towel on the keyboard to protect the screen from scratching. Put the new LCD on the keyboard.

11 Carefully reconnect the video cable and remember it's very fragile, so don't apply too much force. Secure the video connector with the tape.

12 Bend out the tape on the back of the screen, lift the screen up and line it up with the frame.

13 Secure the LCD with the 2 screws on each side.

14 Remove the protective film.

15 Secure the LCD with the 4 frame screws.

16 Now you can test your new screen. Connect the power adapter and press the start button. Once the boot up graphics appear - the screen is installed correctly. Press and hold the power button to cancel the boot up, then disconnect the power adapter in order to finish the installation.

17 Put the bezel back. Start at the bottom, then move up towards the top snapping the bezel around the perimeter.

18 Reinstall the 2 bezel screws at the bottom.

19 Replace the 2 rubber screw covers.

20 Flip the laptop over and reinstall the battery.

21 And you're done!