Replacement of screen on Acer Aspire E15 screen made by LaptopScreen.com

Click here to buy the screen for Acer ASPIRE E15

Par nos clients

Vidéo de notre clientèle remplacement de l'écran sur leur Acer ASPIRE E15 Vidéo de notre clientèle Shadi remplacement de l'écran sur leur Acer ASPIRE E15 Vidéo de notre clientèle Wesley remplacement de l'écran sur leur Acer ASPIRE e15 Vidéo de notre clientèle Natha remplacement de l'écran sur leur Acer ASPIRE E15 Vidéo de notre clientèle Adam remplacement de l'écran sur leur Acer ASPIRE E15

Shut down the laptop

To begin shut down the computer by holding the power button and disconnect the
ac power

Remove bezel

Proceed on removing the bezel in certain cases it is held down with two or four
screws in each corner that can be hidden behind either plastic or rubber covers.
In this case there are no bezel screws. Pull away the bezel by the inner edge
starting from the sides. Be gentle and try not to break any of the plastic tabs
underneath. Sometimes the bezel may also be glued on the inner edge.
Set the bezel asid

Loosen and remove the screws

The lcd is usually mounted with several tiny screws located on the side of the
lcd brackets. Loosen two sometimes three screws on each side where the lcd
mounting bracket are attached to the hinge. To expose the lcd mounting screws
make one or two turns of each screw on the bottom of the lcd mounting bracket.
This should provide sufficient access to the tiny lcd side screws. Remove the
top lcd mounting bracket screws. Remove the lcd mounting screws: two three
or 4 on each side

Disconnect the video cable

Place the lcd panel on the keyboard. Peel the screen tape securing the video cable.
Gently disconnect the video cable. Discard the old panel

Connect the new screen

Place the new lcd panel face down on the keyboard. Reconnect the video cable and
secure it with clear tape. Caution it is very important to not force any of the
connectors. All connectors are extremely fragile. You must not slant the video
connector when plugging it in

Reinstall the new screen

Lift the screen up aligning it with the back cover and remove the protective film.
Replace the left and the right side mounting screws

Test the new screen

At this point we can test out the new screen reconnect the power cable. Turn the
laptop on and if the startup graphics appear the screen is installed correctly
Hold the power button to cancel the boot up

Tighten mounting screws

Tighten the lcd mounting screws at the bottom near each hinge. Replace the top bracket
screws

Replace the bezel

Now we can replace the bezel. Start at the bottom hinge covers and go around the perimeter
snapping its tabs in place. Reconnect the ac power turn on the laptop and you're done!