Replacement of screen on HP 250 G6 screen made by LaptopScreen.com

Tools

For the replacement process we will need the following tools: Phillips screwdriver, Plastic pick

Shut down the laptop

To begin shut the laptop down and disconnect the power cord. Flip the laptop and remove the battery

Remove the bezel

Now we can remove the bezel. Start from the left side. Gently pulling the inner edge of the bezel
away from the glass. Once the edge is unsnapped go around the perimeter unsnapping the tabs at the
top, right side and the bottom. Put the bezel aside

Release the screen

Using a Phillips screwdriver remove two screws holding the LCD panel at the bottom. The LCDs two
top brackets are located under the mounting rails. Remove two Phillips screws holding the LCD and
the mounting rail at the top right corner. Remove two Phillips screw holding the LCDs top left corner.
Pull the mounting rail away from the back cover and release the right bracket. Release the left bracket

Disconnect the screen

Place the LCD on the keyboard. Using a plastic pick gently peel off the clear tape securing the
video connector. Disconnect the video cable. Discard the old panel

Connect the new screen

At this point the new LCD can be installed. Take the new LCD screen and place it on the keyboard.
Reconnect the video cable. Secure it with clear tape. CAUTION! It is very important not to force any
of the connectors. You must not twist or slant the connector when plugging it in

Install the new screen

Lift the screen up. Pull the right mounting rail away from the back cover and place it on top of the LCD
bracket aligning mounting holes. Repeat the same action with the top left mounting rail. Replace two
Phillips screws at the top left and right corners of the LCD screen. Replace two bottom screws

Test the new screen

Now we can test the screen. Reconnect the power cord and turn the laptop on. If the start up graphics
appears the screen is working and we can finish the installation process

Replace the bezel

Remove the protection film. Start replacing the bezel. Start from the bottom. Press firmly snapping
the tabs back in place, then move along the perimeter. Use one hand to support the back cover and
press firmly along the bottom of the bezel.

Replace the battery. Turn the laptop on and we are done!