Replacement of screen on Lenovo Legion 15IMH05H screen made by LaptopScreen.com

Shut down the laptop

To begin turn the laptop off and disconnect the power cord. Normally it is better
to remove the battery but in this case it is too much work to do, so we have to be very
careful with the connectors

Remove the bezel

Start removing the bezel. Pull the inner edge of the bezel away from the glass unsnapping
the tabs underneath. Start from the left side and then go around the perimeter.
Put the bezel aside

Separate the LCD screen

The LCD is glued to the back cover. There are two plastic tabs at the bottom that can be used
to remove the glue from underneath the LCD screen. Use a tweezers to pick up the tab and pull
the tub removing the stretching stripe of glue from the right side. Pick the tub
on the left side and pull out the stripe of glue form the left side. In our case we were able
to partially remove the glue from the bottom part. The screen is still held in place with a glue
on the top. Use a plastic pic to pry off the screen from the back cover. Pull out the remaining
stripe of glue from underneath the screen.on the right side. Remove the remaining glue on the
left side. Place the LCD on the keyboard

Disconnect the video connector

The video connector is secured with a clear tape. Using plastic pick and fingers gently peel off
the tape. Open the connector bracket. Disconnect the video cable. Discard the old panel

Connect the new screen

Take the new LCD screen and place it on the keyboard. Reconnect the video cable and close the
connector's bracket. Secure the connector with a clear tape. CAUTION! It is very important not
to force any connectors. As well you must not twist or slant the connector when plugging it in

Test the new screen

Lift the screen up and lean it on the back cover. We now can test the screen. Turn the laptop on.
The start up graphics appear and we can finish the installation process

Install the new screen with adhesive strips

Your new display is likely to come with no adhesive. We offer standard double-sided adhesive
tape for such repairs on our site: https://www.laptopscreen.com/English/section/tools/
Peel off one piece of tape from the set and apply it on the right side of the back cover making
sure that the tab wouldn't be under the screen, so we can pull the glue out in case we need to
replace the screen again. Remove the protective film from the adhesive. Apply another piece of
tape on the left side of the back cover. Remove the protective film.
Lift the screen up and using a fine micro fibor cloth apply pressure to the display along the edges
to catch the adhesive. Remove the protective film from the new screen

Replace the bezel

Now we can replace the bezel. Start from the bottom pressing firmly to snap the tabs in. Go
around the perimeter. Use one hand to support the back cover while snapping the tabs along
the bottom edge.

Reconnect the power cord. Turn the laptop on. And we are done!