Replacement of screen on Lenovo ThinkPad P15s screen by laptopscreen.com

Tools

For the replacement process we’ll need just a plastic pick and tweezers

Shut down the lapotop

To begin turn off the laptop and disconnect the power cord

Remove the bezel

Using a plastic pick pry off the bezel on the inner edge. The bezel is heavily glued on all
four sides and it takes time and patience to remove it. Move the pick around the perimeter
unsnapping the tabs underneath. Put the bezel aside

Remove two adhesive strips

The screen is held in place with two adhesive strips on the sides. Using tweezers pick up
the loose tab on the right side and pull out the adhesive strip. Pull out the adhesive strip on
the left side

Disconnect the video cable

Now when the screen is released, place it on the keyboard to get access to the video connector.
Remove the clear tape from the video connector. Using a plastic pick open the connectors bracket.
Disconnect the video cable and put the broken screen aside

Connect the new screen

Place the new screen on the keyboard. Carefully align the video connector and using both hands
reconnect the video cable. Close the bracket and secure the cable with clear tape. CAUTION! It
is very important not to force any connectors. Also make sure not to twist or slant the connector
when plugging it in

Test the new screen

Now we can test the screen. Lift the screen up and lean it against the back cover. Turn the laptop
on. The screen is working and we can finish the reinstallation process

Install the new screen using adhesive strips

In order to secure the the screen in the back cover we are going to use a set of adhesive strips,
which you can buy on our site: https://www.laptopscreen.com/English/section/tools/
Use alcohol and a piece of cloth to clean the surfaces on the screen sides. Apply adhesive strips.
Lift the screen up and apply some pressure to catch the adhesive. Make sure that the tabs in the
bottom of the screen are tucked away

Replace the bezel

Go around the perimeter, snapping tabs back in place. Reconnect the power cord, turn the laptop
on and we are done!