Screen Replacement Tool Kit
A must have to repair laptop, tablet and smartphone screens. The Tool Kit includes: Tweezers, Case Opening Tool, Pentalobe Screw Drivers 0.8 1.2 1.5. Phillips Screw Drivers PH000 PH00 PH0 PH1. Torx Screw Drivers T5 T6 T7 T8H T9H T10H Screw Drivers Try-wing 3.0 and Flat 2.5
1/12 inch Double Sided Super Adhesive Tape
Width 1/12 inch (2mm), Length 180ft (55m) Perfect for Cell Phone repairs, Computer Repairs, Tablet Repairs and any other project that requires a more permanent hold.Unique, high-strength acrylic adhesive that can bond plastic, glass, powder coats, lightly oiled metals to the toughest surfaces, quickly and easily.Engineered for performance, endurance, and reliability.
Choose Installation Guide:
Apple MacBook Pro 13 LCD Screen Installation and replacement guide
This is a general LCD replacement tutorial made by LaptopScreen.com. Not your specific model? Click here to search our video library for a model specific guide.
This is a guide on replacing an LCD screen on an Apple MacBook Pro 13".
As the battery for this laptop is not easily removable, you will need to make sure that the laptop is not accidentally powered on during the disassembly and installation process.
2. The LCD panel is behind the front glass, which will need to be removed. The front glass is adhered with double sided tape, so we will be using a heat gun for separation. Start by moving the heat gun around the perimeter of the screen, being careful not to keep the heat in one position for too long. Keep the heat gun 1 to 2 inches away from the glass at all times. Apply heat for just under 2 minutes.
5. Next, insert the entire wide edge of the putty knife in the top left corner of the screen, between the glass edge and the black rubber gasket. Take care not to apply concentrated pressure on the glass, which can occur from the corner of the tool, and may shatter the glass. The putty knife should only be inserted about one millimetre.
22. There are two options for installing the new LCD screen. The first option is to re-connect the video connector to the LCD screen. This will only be possible if the video connector is long enough, and you are able to successfully latch the bracket. Smaller than average fingers, and a high level of patience are required for this.
23. If you possess neither small fingers nor extreme patience, we recommend the 2nd option for installing your LCD screen. First, the back cover of the laptop will need to be removed. There are 10 screws to be removed—4 each on the top and the bottom edge, and 1 on each side.